V8 CDI

1 Take plug out.

2 insert something and touch the piston.

3 move the prop drive CW or CCW., the screw driver will move up or down. You want to find the point where is all way up.

4 Make a mark on the case and prop where you have the TDC.

5. Install on the shaft the timing degree wheel.

6 Make a pointer and fixit on the engine and with the Piston all way up at TDC make the pointer and degree wheel to show “0”

7 best will be to have a piston stop. Screw the piston stop and the prop drive must move CW direction. The degree will start to move CW, screw in until your pointer will show 30 BTDC.

8 Now move the prop drive CCW. (Make sure that pointer or degree wheel does not get disturbed from first original setting) the piston should stop against the piston stop.

9 Read the value. If all was correct, it should show 30 degrees. If you are off from that, 30 degrees target and reads more or less then real careful move the degree wheel by holding the piston against the piston stop.

• 2x3x4 6v to 12v 2 screws,
•  1 sensor THIS DOES NOT
• HOLD POSITION, NEEDS
•  EDITOR LIKE CONTENTS

1. sdfg
2. sdgsdfh
3. fxggfgmjnmmm