CDI – Moki S215, S250, S300

It is  Plug & Play ,just  replace the CDi, Use CH Sensor to replace the Original sensor.

CH Moki  CDI uses a CUSTOM Software .

You can take the original ignition coils from inside the case or if that is to much work, then cut them OFF at the end of the base.

NOTE: A regular 5 CYLINDER CDI WILL NOT WORK!!!

THE CH CDI IGNITION PRODUCED BY CH ELECTRONICS INC., ARE NOT INTENDED FOR POWERING ANY MANNED MACHINERY OR MANNED MEANS OF TRANSPORT. THE COMPANY IS NOT RESPONSIBLE FOR ANY DAMAGE TO PERSONS OR PROPERTY IF ARE USED FOR THIS PURPOSE.

THE CH CDI IGNITIONS ARE FOR ENGINES INTENDED ONLY FOR POWERING RADIO CONTROLLED MODELS, MAINLY MODEL AIRCRAFT AND UNMANNED AERIAL VEHICLES IN WHICH NO PEOPLE ARE TRANSPORTED.

 

• Operating Voltage:  6.0v to 8.4v
• Red/Green LED Sensor activity indicator
• Tachometer Output ( Brown/Red /Orange wires)
• Operating RPM Range: 400 to 6000 RPM
• Rev-Limiter after 6000 RPMS
• Output Start Voltage:  25 KV  400-800 RPM’s
• Output Voltage @ 6000 RPM’s: 25KV
• Hi Voltage wire length: 16 inch  / 410 mm
• Power and Sensor wire length minim: 7 inch / 180 mm
• Dimensions Standard: L 3-15/16″  x  W 1-3/4″ x  H 1-1/4″
• Dimensions Metric:      L 100 mm  x  W 45.5 mm  x  H 32 mm
• Weight: 12 Oz  / 340 Gr